McAfee M-2750 - Network Security Platform Uživatelská příručka stáhnout pdf (Strana 8)

Ping the Manager from the Sensor to determine if your configuration settings to this point have

successfully established the Sensor on the network. At the prompt, type: ping <manager IP

address>.

If the ping is successful, continue with the following steps. If not, type show to verify your

configuration settings and check that the information is correct.

Set the shared secret key value for the Sensor. At the prompt, type: set sensor

sharedsecretkey.

The Sensor then prompts you to enter the shared key value and confirm the same.

This value is used to establish a trust relationship between the Sensor and the

Manager. The secret key value can be between 8 and 25 characters of any ASCII text.

The shared key value is case-sensitive.

Make sure the value matches the shared secret key value you provided in the Manager

interface.

To verify the configuration information, type show. Check that all information is correct.

To exit the session, type exit.

8 Verify successful installation

A handshake process begins between the Sensor and the Manager. The devices will take a few

seconds to establish communication.

Perform the following steps to verify successful communication between the Sensor and the Manager.

In the Sensor CLI, type: status.

The status report appears

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

McAfee M-2750 - Network Security Platform Uživatelská příručka Strana 8