McAfee M-2750 - Network Security Platform Uživatelská příručka stáhnout pdf (Strana 19)

Remove a Sensor from the rack

Because of the weight of the appliance, McAfee recommends that two people remove the chassis from

the rail cabinet. When removing the chassis from the rack, pull chassis forward until you hear the

innermost rails snap in place. On each side of the rails, press in the release button as pictured below

and continue pulling the chassis.

Figure 3-1 Rail release latch for the Sensor

Redundant power supply

A basic configuration of the Sensor includes one hot swappable supply. You may install a second

hot-swappable power supply (purchased separately from McAfee) for redundancy. Each of these

modules has one handle for insertion or extraction from the unit as well as a release latch.

Figure 3-2 Inserting the power supply for the Sensor

Install the power supply

Task

Unpack the power supply from its shipping carton.

Remove the faceplate panel covering the power supply slot.

The faceplate panel should remain in place unless a power supply is in the power supply slot. Do not

operate the Sensor without the faceplate panel in place.

Setting up the Sensor

Redundant power supply

McAfee

Network Security Platform M-2750 Sensor Product Guide

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 37 38

Žádné komentáře

McAfee M-2750 - Network Security Platform Uživatelská příručka Strana 19